Bell Tree Separators - Choose Wire or Acrylic

Wire Bell Tree Separator Clips

These Wire Bell Tree Separator Clips are recommended for bell trees using bells C6 and above. The unique design eliminates swaying and keeps the bell casting from touching the handle of the bell beside it. Install the Bell Clip perpendicular to the handle below it as shown in the image. For larger bells (G4 to B5) we recommend using our Acrylic Belltree Separators.

Directions for Use:
• Position the bells on the table as if you were going to ring them.
• Slide the bell clip onto the handle so that the clip touches the handguard (open end may point either to the left or the right; however, you should be consistent throughout your belltree).

Acrylic Bell Tree Separators

Acrylic Bell Tree Separators (set of 3: 2 long, 1 short) are recommended for bell tree use of bells B5 and below (not recommended for bells below G4). The unique design eliminates swaying and keeps the bell casting from touching the handle of the bell beside it.